How To Set Up Your Wireless Thermometer
•Place the receiver unit as close as possible to the remote unit. This will ensure easy synchronization between the transmission and reception of signals as you set up your wireless thermometer. After set up is completed, position the receiver unit and remote unit within effective transmission range.
Note: The effective range is vastly affected by the building materials and where the receiver and remote units are positioned. Try various set ups for the best results. Shorten the distance between receiver and remote units when necessary.
Important: Though the remote unit is weather proof, it should be placed away from direct sunlight, rain, snow and should never be submerged in water.
Power Sources
Important: Insert the power supply cord into the home receiver first, then install batteries into the remote unit:
Home Receiver
1.Insert the AC adaptor jack into the back of the unit, then insert the cord into a 120V household outlet.
2.Three AA alkaline batteries may be used as a back up or alternate power source: Lift off the battery compartment on the back of the unit, install 3 alkaline AA batteries according to the polarity indicated, and close the battery cover. Note: to conserve battery power, the LCD screen will not be continuously lit when the receiver unit is running only on batteries. To view the screen, press the Snooze/Light button on the top of the receiver unit.
Please note: This digital thermometer is also an extremely sophisticated weather forecasting system. When it is first powered on, the receiver unit will take approximately one minute to analyze its surrounding environmental conditions. This “ANALYZING” mode is indicated by dashes
During this minute, some functions (such as Clock Setting or the NOAA weather radio) may not be operational. Once the “ANALYZING” mode is complete, a default Barometric Pressure appears in place of the dashes. The other system functions will then become operational.
Remote Sensor
1.Lift off the bracket stand, located on the back of the unit, to access the battery compartment cover.
2.Remove the 4 screws that secure the battery compartment cover and then remove the cover.
3.Select the Channel setting by sliding the CH switch to Channel 1 to register the first sensor, included in this package.
5
