INSTALL BATTERIES IN THE WEATHER STATION: |
|
| ||||
Wall mount hole |
|
|
|
|
|
|
|
|
|
| |||
Function buttons |
|
|
|
| Battery compartment | |
|
| |||||
|
|
|
|
|
| Battery cover |
|
|
|
|
|
| Foldout stands |
|
|
|
|
|
| |
Remove the battery cover from the weather station:
Insert a finger in the rounded depression at the bottom of the battery cover.
Lift up and pull out to remove battery cover.
Install two fresh AA alkaline batteries according to the polarity markings. Replace battery cover.
Within 30 seconds of powering up the transmitter, insert batteries into the Weather station, observing the correct polarity. Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature will be displayed. If the indoor temperature is not shown in the LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them.
TEMPERATURE SELECTION:
FAHRENHEIT/CELSIUS:
Weather station: Press and release the 
Transmitter: Remove the battery cover then press and release the C/F button on the transmitter to select Fahrenheit or Celsius.
Channels: If more than one transmitter is used, set each transmitter to a different channel. To
view: press the CH button to select Ch1, Ch2, Ch3 and
above the channel number and will rotate through each channel approximately every
4
