La Crosse Technology WS-7014U Mounting Remote Control Sender, Mounting with Screws

MOUNTING

Note: Before permanently mounting ensure that the Indoor Temperature Station is able to receive WWVB signals from the desired location. Also, extreme and sudden changes in temperature will decrease the accuracy of the Weather Station, and changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data. To achieve a true temperature reading, avoid mounting where direct sunlight can reach the Remote Control Sender or Weather Station. While the Remote Control Sender is weather proof, avoid submersion in water or snow. We recommend that you mount the Remote Control Sender on an outside North-facing wall. The sending range is 80ft—obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in their desired location, and wait approximately 10 minutes before permanently mounting to ensure that there is proper reception. The Indoor Weather Station should display a temperature in the OUTDOOR LCD within 4 minutes of setting up.

I. THE REMOTE CONTROL SENDER

The Remote Control Sender can be mounted in two ways:

•with the use of screws, or

•using the adhesive tape.

A. MOUNTING WITH SCREWS

1)Remove the mounting bracket from the Remote Control Sender.

2)Place the mounting bracket over the desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil.

3)Where marked, start the screw holes into mounting surface.

4)Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket.

17