INVENTORY OF CONTENTS
1.Two indoor weather stations (Figure 1)
2.The remote temperature/humidity sensor (TX4U) and mounting bracket. (Figure 2)
3.Mounting hardware.
4.Instruction Manual and Warranty Card.
Figure 1
Figure 2
ADDITIONAL EQUIPMENT (not included)
1.1 Philips screwdriver.
2.4 Fresh AA 1.5V batteries.
(2 for each indoor weather station)
3.2 Fresh AA 1.5V batteries. (for temp/humidity sensor)
QUICK SETUP
Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.
1.Have the indoor weather stations and remote temp/humidity sensor 3 to 5 feet apart.
2.Batteries should be out of all units for 10 minutes.
3.Place the batteries into the remote temp/humidity sensor first, then into the indoor weather stations. (All remote temp/humidity sensors must be started before the indoor weather stations)
4.DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.
In this time the indoor weather stations and remote temp/humidity sensor will start to talk to each other and the displays will show both the indoor temperature and an outdoor temperature and humidity. If the indoor weather stations do not display both the indoor temperature and the outdoor temperature and humidity after the 15 minutes please retry the set up as shown on page five.
