La Crosse Technology WS-7394U Detailed SET-UP Guide, Battery Installation, Indoor Weather Station

DETAILED SET-UP GUIDE

I.Battery Installation

Batteries will fit tightly. To avoid start-up problems, make sure that the batteries do not spring free. Also be sure to insert alkaline batteries into the remote temperature sensor first, then the indoor weather station. Initial set up should be done with the remote temperature sensor and indoor weather station in the same room. The units should be permanently mounted only after the signal reception has been verified.

A.Remote Temperature and Humidity Sensor

1.Remove the mounting bracket. The bracket snaps on and off easily.

2.Remove the battery cover, by sliding the cover down.

3.Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free).

4.4. Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

B.Indoor Weather Station

1.Remove the battery cover (the cover has white writing on it).

2.Observe the correct polarity, and install two Alkaline AA batteries.

3.Do not press any buttons for at least ten minutes. If a button is pressed before the indoor weather station has received information from the TX4U sensor, no data will be received from that sensor until reset.

4.Replace the battery cover.

Battery Cover

5