VII. MOUNTING
Note: Before permanently mounting, ensure that the indoor weather station is able to receive signals from the sensors and WWVB signal at the desired location. To achieve a true temperature reading, avoid mounting the remote temperature sensor (or any sensor) where direct sunlight can reach the remote sensor. We recommend that you mount the remote sensor on a
A.Mounting the Remote Temperature Sensor
The remote temperature sensor can be mounted in two ways:
•with the use of screws
•using the adhesive tape
1.MOUNTING WITH SCREWS
a.Remove the mounting bracket from the remote temperature sensor.
b.Place the mounting bracket over the desired location.
c.Through the three screw holes of the bracket, mark the mounting surface with a pencil.
d.Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket.
e.Insert the remote temperature sensor into the bracket.
2.MOUNTING WITH ADHESIVE TAPE
a.With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat.
b.Remove the protective strip from one side of the tape.
c.Adhere the tape to the designated area on the back of the mounting bracket.
d.Remove the protective strip from the other side of the tape.
e.Position the remote temperature sensor in the desired location, ensuring that the indoor weather station can receive the signal.
19
