TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE SENSOR
The sensor uses 2 x AA,1.5V batteries. To install and replace the batteries, please follow the steps below:
1.Remove the cover.
2.Insert the batteries, observing the correct polarity (see marking inside battery compartment).
3.Replace the battery cover on the unit.
Alkaline batteries are recommended for use in both units. Avoid using rechargeable batteries.
SETTING UP:
Alkaline batteries are recommended for use in both units. Avoid using rechargeable batteries.
NOTE: Do not set the clock until the outdoor temperature is displayed.
1. | Place batteries in the outdoor sensor first, then into the atomic clock. DO NOT PRESS |
| ANY BUTTONS FOR 10 MINUTES. |
2. | Once the batteries are in place, all segments of the LCD will light up briefly. Following the |
| indoor temperature, date, weekday, and the time as 12:00 will be displayed. If they are not |
| shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds |
+ key | : To toggle between the second, temperature or weekday display |
| To change any values in manual set mode |
ALM key | : To enter into the alarm set mode |
| To display the alarm time in normal mode display |
| To set the alarm ON/OFF |
SNZ key | : To activate the snooze function during alarm |
| To exit the setting modes |
ATOMIC CLOCK LCD SCREEN DESCRIPTIONS
The atomic clock's LCD is divided into 2 sections and once the batteries are inserted, all the segments will light up briefly before displaying the information for time, date, indoor and outdoor temperatures.
WWVB time |
| Low battery indicator (atomic clock) |
|
|
Alarm icon
| before reinserting them. Once the indoor data is displayed user may proceed to the next |
| step. |
3. | After the batteries are inserted, the atomic clock will start receiving data signal from the |
| sensor. The outdoor temperature should then be displayed on the atomic clock. If this does |
| not happen after 2 minutes, the batteries will need to be removed from both units and reset |
| from step 1 and the signal reception icon is no longer shown. |
Indoor temperature
Date
MANUAL SETTINGS
Outdoor temperature display
Weekday
Low battery indicator (sensor)
Note:
In the event of changing batteries of the unit ensure that the batteries do not spring free from the contacts. Always wait at least 10 minutes after removing the batteries before reinserting, otherwise start up and transmission problems may occur.
FUNCTION KEYS
The atomic clock has four easy to use keys:
SET key : To enter into the set mode for the following functions: time zone, DST ON/OFF (daylight saving time), language, hour, minute, year, month, day, weekday, 12/24 hour, ºC or ºF temperature display
3
Note:
If the atomic clock has already successfully received the WWVB time signal and displays the correct time and date, then the Manual settings can be skipped.
After completion of the above described procedures in “Setting up” the manual setting modes can be entered by pressing and holding the SET key for 3 seconds. The following settings can now be programmed:
•Time zone setting
•DST ON/OFF
•Language display setting
•Manual time setting
4
