LaCie user manual Quick Start, LaCie 319 LCD Monitor, User’s Manual, page

LaCie 319 LCD Monitor	2. Quick Start
User’s Manual	page 12

2. Quick Start

To attach the LaCie LCD Monitor to your system, follow these instructions:

1.Turn off the power to your computer.

2.For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D-SUB to DVI-A signal cable to the connector of the display card in your system (Figure A.2).

For the MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure B.1).

Macintosh

Figure A.1Figure A.2 Cable Adapter Figure B.1

(not included)

NOTE: Some Macintosh systems do not require a Macintosh cable adapter.

3.Connect the DVI signal cable to the connector on the back of the monitor. Place the video signal cable (Figure C.1). Connect only either VGA or DVI to input 2.

NOTE: Incorrect cable connections may result in irregular operation, damage display quality/components of LCD module and/or shorten the module’s life.

Collect cables and keep them in the stand with attached cable cover. The cable cover can be attached on the front or back side of Tilt Stand (Figure C.1, C.2).

Please check Tilt, Rise and Lower monitor screen and screen rotation when you manage cables.

4.Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet (Figure C.1).

NOTE: Please refer to Caution section of this manual for proper selection of AC power cord.

5.The Vacation Switch on the left side of the monitor must be turned on. Turn on the monitor with the front power button (Figure D.1).

NOTE: The Vacation Switch is a true on/off switch. If this switch is on the OFF position, the monitor cannot be turned on