How To Use, USE AS BY DAY Use as Air Circulator

WARNING

ELECTRICAL SHOCK HAZARD

Do not use near water or other fluid.

Use your fan only in dry environments. Do not place fan in bathroom, laundry area, or similar locations, or near sinks, washing machines, swimming pools or other sources of water. Never locate fan where it may fall into a bathtub or other water container. Do not use outdoors. Do not use in damp environ- ments such as flooded basements or garages.

WARNING

FIRE HAZARD

Do not use near combustible materials or flammable gasses or sources of heat.

To reduce the risk of fire or electric shock, do not use this fan with any solid state speed control device such as a dimmer switch.

Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause electric shock, and/or a fire hazard.

To Avoid Overloading Motor: Do not leave fan where drapes or curtains will get pulled into the fan or against the fan guard.

A fan has sparking parts inside. Do not use it in areas where gasoline, paint, or flammable materials are used or stored. This fan contains flammable materials and if ignited will support and spread fires.

WARNING

ELECTRICAL SHOCK HAZARD

Use with adequate electrical system.

Do not use with damaged cord or plug.

This appliance has a three-prong grounded plug that must be insertedintoamatchingoutlet. Toreducetheriskofelectricshock, the grounding plug must not be cut off the plug. Where a two- prong wall outlet is encountered, it must be replaced; contact a qualified electrician. Do not use the three-prong plug with a two- prong adapter. DO NOT attempt to defeat this safety feature.

UseyourfanonlywithadequatewiringthatisuptoCode.Connect to properly grounded outlets only.

Do not operate any fan with a damaged cord or plug or after the fan malfunctions, has been dropped or damaged in any man- ner. For repairs covered under warranty, see warranty state- ment. For all other repairs contact Lakewood’s customer service by telephone or mail for information and assistance.

Do not route cord under carpeting. Do not cover cord with throw rugs, runner, or the like. Arrange cord away from traffic area and where cord will not be tripped over.

DO NOT attempt to defeat any of these safety features or instructions.

PLEASE READ BEFORE OPERATING

ASSEMBLY INSTRUCTIONS HV-21 (with 3 piece stand)

•Remove fan and base tube from carton.

•Place fan face down (nameplate down) on floor.

•Rotate the two short legs that are attached to the grille into a straight up position.

•Position stand as shown in drawing, with rear of the base tube close to the switch.

•Depress button on one leg, and slide the base tube onto that leg. Make sure that the button is engaged in the hole in the base tube.

•Depress button on the other leg, and slide the base tube onto that leg. Make sure that the button is engaged in the hole in the base tube.

•Failure to ensure that both buttons are engaged in the base tube holes

can lead to in- jury to persons or damage to property.

•Attach rubber feet contained in plastic bag to the base tube per the enclosed in- structions.

•Plug the female end of the power cord in below the controls.

•Set fan upright onto rubber feet, rotate to the desired angle and plug the cord into a properly grounded electrical outlet. Your fan is now ready to use.

HOW TO USE:

•Plug fan directly into 120 volt AC wall outlet. Be sure plug fits tightly in outlet. A loose fit will cause overheating and damage to the plug. Always operate fan on its base in the normal upright position.

•Set the selector switch to the desired position.

•Todisconnectfan;turnswitchoff,thenremoveplugfromoutlet.