Land Pride 309-100M manual Table of Contents, Operating Instructions

Land Pride Table of Contents

Section 2: Operating Instructions

You should now be ready to move to the cutting site to begin mowing. You should have inspected and should only be cutting in an area you are familiar with which is relatively free of debris and unseen objects. Never assume an area is clear and extremely tall grass or brush should be cut twice to detect potential hazards. In the event you do strike an object, stop the tractor and cutter immediately to inspect the rotor and make any necessary repairs before resuming operation. It pays to inspect a new area and to develop a plan before you cut.

Normal mowing speed will be between 2-5 mph and you will need to maintain tractor PTO speed to produce a clean cut so make a tractor gear and range selection that will maintain this combination. Generally the quality of cut or degree of debris pulverization will be better at lower ground speeds and cutting denser ground cover or heavier brush may create the need to slow down. Always cut downward on slopes and avoid crossing the face of steep slopes. Avoid sharp drops and cross diagonally through dips to prevent hanging up the tractor and mower. Slow down in turns and avoid sharp turns if at all possible. Remember to look back often. Always be aware and extremely cautious when there are people, pets, livestock, and valuable property in your immediate operating vicinity.

Now you’re prepared and well briefed so lets begin cutting. Reduce the tractor’s engine rpm, make sure the mower is on the ground and in cutting position, engage the PTO, raise the engine rpm to the appropriate PTO speed, and begin mowing. Operators must plan ahead and choose a cutting route that allows safe turns. Try increasing or decreasing ground speed to determine the effect on quality of cut. With a little practice you will be pleased with what you and your Land Pride Flail mower can do.

Dense growth will require more horsepower and will cause you to slow down especially if you are encountering material up to 1" in diameter. The fine cut knives on either unit are much better suited for a finer quality of cut in grass cutting applications and in no case should fine cut blades be used for cutting material greater than 1’ in diameter.

When you are done mowing, need to take a break, or just need to make a few adjustments to the mower, remember to always do the following. Reduce the tractor’s engine rpm, disengage the PTO, stop on level ground, set the park brake, turn off the engine, and remove the key. Land Pride flail mowers are very user friendly and easy to operate. With a little practice you should be operating your Land Pride Flail Mower like an expert in no time at all.

3/25/08 FM2060 & FM2072 Flail Mowers 309-100M 11