Land Pride 22081 Engine Air Filter, Air Filter Maintenance Schedule, Air Filter Replacement Parts

Table of Contents

Section 6 Maintenance

7.Remove belt by rolling it off over the drive pulley and then lifting it up off the driven pulley.

8.Reinstall new belt by placing it over the driven pulley and then rolling it over the drive pulley.

9.Re-tension power steering belt and tighten take-up bolt.

10.Reinstall belt cover and fasteners.

11.Reconnect battery negative cable.

12.Remove blocks securing cargo box up and lower cargo box.

Engine Air Filter

Refer to Figure 6-8

A specially designed high density paper filter element surrounded by an oil filled foam precleaner filter element cleans the air supplied to the engine. Protect your engine by ordering only genuine Land Pride parts when replacing the air filter elements.

NOTE: Do not operate engine with a damaged air filter or without the air filter elements installed. Dirt will enter the engine and cause a dust ingested engine failure.

Air Filter Maintenance Schedule

•Check air filter daily before starting engine for dirt and debri buildup. Also check daily for loose and damaged filter components. Tighten loose components and replace damaged components.

•Service precleaner foam element ever 25 hours of operation. Service more often when operating in extremely dusty or dirty conditions.

•Service paper element every 100 hours of operation. Service more often when operating in extremely dusty or dirty conditions.

Air Filter Replacement Parts

Order genuine Land Pride parts when replacing the precleaner element.

Description Part No.

Precleaner Element (61 mm deep) . . . . 24-083-02-S Paper Element (65 mm deep) . . . . . . . . . 47-083-03-S

Precleaner Foam Element

Refer to Figure 6-8and Figure 6-9

1.Prepare vehicle for maintenance as outlined in steps 1-6 on page 24.

2.Safely secure the seat console in the raised position.

3.Loosen air cleaner cover knob and remove cover.

4.Remove outside precleaner element from the paper element.

5.Wash precleaner element with warm water and detergent. Rinse thoroughly to remove all traces of detergent. Do not wring precleaner. Squeeze excess water out and allow time to air dry.

6.Saturate precleaner with new engine oil and gently squeeze all excess oil out.

7.Inspect precleaner element for holes and tears before reinstalling it. Replace element if damaged.

8.Reinstall precleaner element over the paper element being careful not to damage the elements.

9.Reinstall air cleaner cover and secure with cover retaining knob.

Air Cleaner Cover Air Cover Knob

21368

	Figure 6-8
Element	Element Cover
Cover	Wing Nut

Paper Element

Behind Precleaner

	Precleaner Foam
	Element
21369
	Figure 6-9
Air Cleaner	Rubber Seal On
	Air Cleaner Stud
Base

21370

Figure 6-10

30 4400EX Heavy Duty Off Road Utility Vehicle 720-132M 7/01/05