Land Pride | Table of Contents |
Section 1: Assembly & Set-up
General Description
The 25 Series Grooming Mower is shipped crated and partially assembled. Unloading and assembly of this grooming mower is the responsibility of the Land Pride Dealer. The mower should be completely assembled, lubricated, and Adjusted for normal mowing operations before delivery to the customer.
Tools Required
•Sufficient Lifting device (e.g., fork lift, hoist, tractor) see “Specification Chart” for unit weight.
•Support Stands
•Regular Hand Tools
•Grease Gun
!CAUTION
Always wear personal protection devices such as eye, ear, and feet protectors during assembly operations.
Assembly Instructions
Using a safe lifting device, set the crate on safe supporting stands. Remove crate. Remove loose components - gauge wheels, gauge wheel arms and miscellaneous hardware from the top of deck. Arrange parts for easy identification.
Upper Hitch Arms
Refer to Figure 1-2:
1.Loosen 5/8" x 1 3/4" long bolts (#1) and swing upper hitch (#2) up to a vertical position.
2.Remove 5/8" x 5 1/2" long bolt (#3) and install upper hitch brace (#4), upper pivoting hitch (#5), and hitch spacer (#6) with 5/8" x 5 1/2" long bolt (#3).
3.Refer to Figure
Lower Hitch Lugs
Refer to Figure
The Hitch Lug (#1) is installed from the factory in the inward most position on the mower channel (#2).
1.Remove hair pin (#4). Remove pivot pin (#3)
2.Slide hitch lugs (#1) into the initial position as shown in Figure
13543
Lower Hitch Lugs
Figure
Initial Hitch Arm Position
Refer to Figure
1.Bolt the upper hitch arms and lower hitch lugs on the mower to the positions shown
2.Tighten hardware to listed torque values.
11915
| 13542 |
Upper Hitch Arms Assembly | Initial Hitch Arm Position |
Figure | |
Figure |
|
10/11/06 | FD2560, FD2572, AT2560 & AT2572 Grooming Mower, | 9 |