Land Pride | Table of Contents |
Section 2: Operating Instructions
Operating Instructions
Pre-Start-up Checklist
Read and follow the “Safety Rules” carefully.
Oil Level in gearbox
All plugs and caps in gearbox have been replaced and tight- ened properly.
All mower blades, bolts & nuts are tight
Inspect the blades. Make note of the wear to the blades and the sharpness of the blades.
All guards and shields are in place and secure.
Grease PTO shaft and all other grease fittings.
Make a thorough examination of the PTO shafts. Also check the connection to the gearbox and tractor PTO.
Clear the area to be mowed of rocks, branches and other for- eign objects.
1.Clear the area to be mowed of objects and debris that might be picked up and thrown by the mower blades.
2.Grass is best cut when it is dry. Mowing wet grass can cause plugging resulting in grass clumps behind the mower.
3.Grass should be mowed frequently as shorter clippings deteriorate faster.
4.If mowing extremely tall grass, it is best to raise cutting height and mow the area, then lower cutting height and mow a second time at the desired height.
5.Lower mower to ground. Set tractor throttle at approximately 1/4 open. Engage PTO to start blades rotating.
6.Operate only with 540rpm PTO tractor.
7.At first, begin mowing at a slow forward speed and shift up until the desired speed is achieved - maintaining 540 PTO rpm.
8.Mower blades will cut better at a faster rotor speed than at reduced throttle.
9.After mowing the first 50 feet, stop and check to see that the mower is adjusted properly.
10.Do not make sharp turns or attempt to back up while mower is on the ground.
11.Do not engage PTO with mower in the fully raised position. Do not engage PTO at full throttle.
12.After mowing disconnect tractor PTO and follow transporting procedures.
Transporting
!CAUTION
Always disengage tractor PTO before transporting mower to avoid injury from thrown objects or blade contact.
!CAUTION
When traveling on public roads whether at night or during the day, use accessory lights and devices for adequate warning to operator’s of other vehicles. Comply with all federal, state and local laws.
!CAUTION
The mower is wider than your tractor so care should be taken when encountering oncoming traffic and roadside obstructions.
IMPORTANT: Always disengage PTO before raising the mower to transport position.
1.When raising the mower to the transport position, be sure that driveline does not contact tractor or mower. Adjust the tractor’s
2.Be sure to reduce tractor ground speed when turning; and, leave enough clearance so the mower does not contact obstacles such as buildings, trees or fences.
3.Select a safe ground travel speed when transporting from one area to another. When traveling on roadways, transport in such a way that faster moving vehicles may pass you safely.
4.When traveling over rough or hilly terrain, shift tractor to a lower gear.
!CAUTION
When mowing in sandy soil areas, wear may occur to your mower blades caused from sand erosion. Frequent inspection should be made and blades replaced if damaged
10/11/06 | FD2560, FD2572, AT2560 & AT2572 Grooming Mower, | 13 |
