Table of Contents
Important Safety Information
Land Pride
These are common practices that may or may not be applicable to the products described in this manual.
Use Safety
Lights and Devices
▲Slow moving tractors, self- propelled equipment, and towed implements can create a hazard when driven on public roads. They are difficult to see, especially at night.
▲Flashing warning lights and turn signals are recommended whenever driving on public roads. Use lights and devices provided with implement.
Transport
Machinery Safely
▲Comply with state and local laws.
▲Maximum transport speed for implement is 20 mph. DO NOT EXCEED. Never travel at a speed which does not allow adequate control of steering and stopping. Some rough terrain require a slower speed.
▲Sudden braking can cause a towed load to swerve and upset. Reduce speed if towed load is not equipped with brakes.
▲Use the following maximum speed - tow load weight ratios as a guideline:
▲20 mph when weight is less than or equal to the weight of tractor.
▲10 mph when weight is double the weight of tractor.
▲IMPORTANT: Do not tow a load that is more than double the weight of tractor.
Use A Safety Chain
▲A safety chain will help control drawn machinery should it separate from the tractor drawbar.
▲Use a chain with the strength rating equal to or greater than the gross weight of the towed machinery.
▲Attach the chain to the tractor drawbar support or other specified anchor location. Allow only enough slack in the chain to permit turning.
▲Do not use safety chain for towing.
Practice Safe Maintenance
▲Understand procedure before doing work. Use proper tools and equipment, refer to Operator’s Manual for additional information.
▲Work in a clean dry area.
▲Lower the implement to the ground, put tractor in park, turn off engine, and remove key before preforming maintenance.
▲Allow implement to cool completely.
▲Install all transport locks on raised drill before working underneath, refer to the Operator’s Manual for quantity and location of transport locks.
▲Do not grease or oil implement while it is in operation.
▲Move the opener handle to the “ROAD” position and complete raising the openers to lock them up before working underneath them.
▲Disk edges are sharp. Be careful when working in this area.
▲Disconnect battery ground cable
▲Inspect all parts. Make sure parts are in good condition & installed properly.
▲Remove buildup of grease, oil or debris.
▲Remove all tools and unused pars from implement before operation.
2 | FD2560, FD2572, AT2560 & AT2572 Grooming Mower, | 10/11/06 |
