Land Pride | Table of Contents |
Section 6: Features & Benefits
| DT(M)55 Series Powered Ditcher |
|
|
Features | Benefits |
|
|
HP range | 70 - 120 HP |
|
|
Cat. 2 & 3 | Fits wide variety of tractors. |
|
|
Quickly and easily attach Ditcher to tractor with one person. | |
|
|
Formed tubing hitch | Formed tubing with 1/4” wall offers greater strength vs. plate steel hitch. |
|
|
540 & 1000 rpm models | Allows fitting larger tractors that are 1000 rpm only. Driveline available in 1 3/8” or 1 3/4”. |
|
|
20” Impeller | 20” Impeller digs a nice size drainage or irrigation ditch. |
|
|
6 Blades on impeller | 6 Blades make digging easier and smoother than fewer blades. |
|
|
3/8” Blades | |
|
|
3/8” Hardened cutting edge | Impeller blades feature a replaceable hardened edge to take on rough and rocky |
| conditions. Easier and more cost effective to replace edge vs. using hard faced material on |
| impeller. |
|
|
Double 80 chain | Double 80, high tensile roller chain keeps stretching to a minimum and has the strength |
| needed to take shock loads posed by extreme digging conditions. |
|
|
Spring loaded chain idler | Chain idler is spring loaded to keep constant tension on chain during tough digging |
| conditions, which also makes for smoother digging operations. |
|
|
Hardened tooth sprockets | Hardened tooth sprockets have the strength needed to take the load of the double 80 |
| chain and rigorous digging conditions. |
|
|
2Greasable flange bearings | Input and output shafts feature 2 1/4” ID ball type bearings. Ball bearings offer smooth and |
| quiet operation. Bearings are greasable to keep properly lubricated and purge dirt out. |
|
|
Bearings are housed in a | |
| protection under extreme use. |
|
|
Cat. 5 | |
|
|
Depth controlling skid shoe | Replaceable 3/8” thick skid shoe for long life and uniform depth control. |
(optional) |
|
|
|
Material control chute | Material control chute allows the operator to place material just outside the tractor path, to |
(optional) | as far away as the Ditcher will throw it. Control the throwing distance by raising or lowering |
| the chute with either a 2” x 8” hydraulic cylinder or ratchet jack. |
|
|
Depth control wheel (optional) | 16.5 x |
| the ground to 10” deep. |
|
|
Ripper shank (optional) | For hard packed soils, the Shank rips up the ground just ahead of the impeller, allowing the |
| impeller to take in the soil vs. bouncing on hard packed soil. Shank has 3 height |
| adjustments from cutting edge depth to 5” below cutting edge. |
|
|
3/17/08 | DT55 & DTM55 Powered Ditchers | 21 |