Table of Contents
Section 1: Assembly and Set-Up
Land Pride
Tractor Requirements
This Powered Ditcher is designed with a Category 2 and 3,
!CAUTION
Your Ditcher must be mounted only on a tractor equipped with a Category 2 or 3 hitch. Failure to do so may result in serious injury.
Driveline Set-Up
If the Ditcher is to be used on more than one tractor, an additional driveline may be required - especially if a quick hitch is used.
!CAUTION
Do not use a PTO adaptor with a quick hitch. A PTO adapter will increase the strain on the tractor’s PTO shaft and can damage the PTO shaft and tiller driveline.
!WARNING
Tractor Hook-Up
Damaged drivelines can cause serious injury or death.
!DANGER
Tractor
!DANGER
Hydraulic fluid under pressure can penetrate skin. Wear protective gloves and safety glasses or goggles when working with hydraulic systems. Use a piece of cardboard or wood rather than hands when searching for hydraulic leaks. If hydraulic fluid is injected into the skin, it must be treated by a doctor within a few hours or gangrene may result.
1.Slowly back tractor up to the Powered Ditcher while using the tractor’s
2.Engage tractor park brake, shut tractor engine off and remove key before dismounting from tractor.
3.With tractor’s lower hitch arms aligned and positioned in the clevises, attach the lower arms to the clevises with hitch pins and secure with linch pins.
4.Connect top center link to the upper pivot hitch using customer supplied clevis pin and linch pin.
5.Ensure that the lower hitch arms are blocked to prevent excessive side movement.
6.Return to the tractor and slowly operate the
7.Manually adjust one of the two lower lift arms up or down to level the Powered Ditcher from left to right. Manually adjust the length of the
!CAUTION
Tractor PTO shield and all Ditcher guards must be in place at all times during operation!
IMPORTANT: Some tractors are equipped with multispeed PTO ranges. Be certain your tractor ‘s PTO is set for the correct PTO speed.
IMPORTANT: Avoid premature driveline breakdown. A driveline that is operating must not exceed an angle of 25 degrees up or down while operating the
24872
Maximum Allowable Driveline Movement
Figure
Checking Driveline Minimum Length
IMPORTANT: Always check driveline minimum length and maximum allowable length during initial setup and when connecting to a different tractor. More than one driveline may be required to fit all applications.
8 | DT55 & DTM55 Powered Ditchers | 3/17/08 |