Table of Contents
Section 1: Assembly and Setup
Land Pride
Blade Offset Cylinder
Refer to Figure 1-6:
IMPORTANT: Attach cylinder base to the front hitch lug. The cylinder base will interfere with the main frame if attached to the rear lug.
Assemble hydraulic hoses to the hydraulic cylinder before placing cylinder on the blade.
1.Position hydraulic cylinder with ports on top. Install two 90 degree elbows into the cylinder ports and tighten as needed.
2.Screw 96" long hydraulic hoses into the elbows and tighten. Use 101” long hydraulic hoses when sing a Quick Hitch.
3.Thread adapter fittings to the other end of the hydraulic hoses and tighten. (Hydraulic couplings not furnished.)
4.Attach hydraulic cylinder to the lugs located on either side of the Rear Blade with clevis pins. Make sure hydraulic ports are positioned on top and the cylinder base in positioned to the front as shown.
5.Secure clevis pins with hair pin cotters.
6.Route hoses through hose brackets located on top of the main frame and on the right side of the front hitch. Connect hoses to tractor's hydraulic system.
Blade Tilting Cylinder
Refer to Figure 1-6:
IMPORTANT: Attach cylinder base to the upper mounting lug.
Assemble hydraulic hoses to the hydraulic cylinder before placing cylinder on the blade.
1.Position hydraulic cylinder with ports on top. Install two 90 degree elbows into the cylinder ports and tighten as needed.
2.Screw 114" long hydraulic hoses into the elbows and tighten. Use 125” long hydraulic hoses when sing a Quick Hitch.
3.Thread adapter fittings to the other end of the hydraulic hoses and tighten. (Hydraulic couplings not furnished.)
4.Attach hydraulic cylinder to the lugs located on the back of the Rear Blade with clevis pins. Make sure hydraulic ports are positioned facing forward and the cylinder base in positioned up as shown.
5.Secure clevis pins with hair pin cotters.
6.Route hoses through hose brackets located on top of the main frame and on the right side of the front hitch. Connect hoses to tractor's hydraulic system.
Blade Tilting
Blade Angling
15004
Hydraulic Tilt and Offset Assembly
Figure
8 | RB4596, RB45108 & RB5596 Rear Blade | 5/21/07 |
