Land Pride RB45108 manual Manual Blade Offset, Manual Blade Tilting, Skid Shoe Option, Kit Bundle

Land Pride Table of Contents

Section 1: Assembly and Setup

Manual Blade Offset

Refer to Figure 1-7:

1.Attach blade offset links to the left or right side

of the blade as shown with two clevis pins and secure with hair pin cotters.

2.Adjust offset angle by removing the hitch pin and moving outer link to a different hole. Replace hitch pin and secure with hair pin cotter.

Manual Blade Tilting

Refer to Figure 1-7:

1.Attach ratchet jack to the back side of the blade as shown with two 1" clevis pins and secure with hair pin cotters.

2.Adjust blade tilt by setting the lock on the ratchet lever and pumping the lever back and forth to raise one end of the blade higher than the other end. Reposition ratchet lock and pump lever back and forth to tilt blade in the opposite direction.

Skid Shoe Option

Refer to Figure 1-8:

The skid shoes are attached to both ends of the blade to help prevent damage to the surface of the ground by the blade.

Kit Bundle

301-110A SKID SHOE ASSEMBLY

1.Attach skid shoe bracket (#1) with 1/2"-13 x 4 1/2" GR5 hex head cap screw (#5), flat washers (#6), spring lock washer (#7) and hex nut (#8). Tighten hardware to the correct torque.

2.Insert skid shoe (#2) into skid shoe bracket (#1). Secure with clevis pin (#3) and hair pin cotter (#4).

3.Repeat steps 1 and 2 for the other side.

10350

Skid Shoe Assembly

Figure 1-8

Blade Tilting

Blade Angling

15003

Manual Tilt and Offset Assembly

Figure 1-7

5/21/07 RB4596, RB45108 & RB5596 Rear Blade 301-133M 9