Land Pride RB5596 manual Tractor Hook-Up, RB55 3-Point Hitch Settings, Category ll Standard Hitch

Land Pride Table of Contents

Section 1: Assembly and Setup

Tractor Hook-Up

Refer to Figures 1-2, 1-3, 1-4 & 1-5:

!DANGER

Tractor hook-up to equipment is dangerous and can result in serious injury or death. Do not allow anyone to stand between the blade and tractor during hook-up operations. Do not operate the hydraulic 3-point lift controls while someone is directly behind the tractor or near the blade.

1.Slowly back tractor up to the Rear Blade while using tractor’s 3-point hydraulic control to align the lower hitch link holes with lower hitch clevis holes on the blade.

2.Engage park brake, shut engine off and remove key before dismounting from tractor.

a.With tractor’s lower hitch arms aligned and positioned in the clevises, insert hitch pins through the clevis lugs and lower arm holes. Be sure to use the bushings as shown in Figures 1-3, 1-4 & 1-5. Secure hitch pins with linch pins.

3.Connect top center link to the upper pivot hitch mounting holes using customer supplied clevis pin and linch pin.

4.Ensure that the lower hitch arms are blocked to prevent excessive side movement.

5.Remove hitch pin and raise support stand fully up. Reinsert hitch pin and secure with lock pin.

6.Return to tractor and slowly operate controls up and down to check for clearance. Make certain the blade does not interfere with the tractor hitch, tires, and drawbar. Move or remove the drawbar if it interferes.

7.Manually adjust one of the two lower lift arms up or down to level the blade from left to right.

8.Manually adjust length of the top-link to level the blade from front to rear.

23998

RB55 3-Point Hitch Settings

Category ll Standard Hitch:

Refer to Figure 1-3:

Hitch pins (#2) are inserted from the outer lug. Place spacer adapter (#1) on hitch pin (#2) outside of the inner most lug and secured with lock pin (#3).

11922

Category ll Standard Hitch

Figure 1-3

Category ll Quick Hitch:

Refer to Figure 1-4:

Bushings (#2) are positioned next to the outer most hitch lug with hitch pins (#3) inserted from the inner most lug. Place spacer adapter (#1) on hitch pin (#3) outside of the outer most lug and secured with the lock pin (#4).

11921

Category ll Quick Hitch

Figure 1-4

Category lll Standard Hitch:

Refer to Figure 1-5:

Bushings (#2) are positioned next to the inner most hitch lug with hitch pins (#3) inserted from the outer most lug. Place spacer adapter (#1) on hitch pin (#3) outside of the inner most lug and secured with the lock pin (#4).

10355

Tractor 3-Point Hitch	Category lll Standard Hitch
Figure 1-2	Figure 1-5

5/21/07 RB4596, RB45108 & RB5596 Rear Blade 301-133M 7