Lantronix LMS8-A manual Installation Tips, Power Requirements

Installation Tips

Note: These tips are additional to the Installation Instructions that can be found on the back of the unit.

▼All ports on the LMS8-A can support full duplex operation - please make sure that each port has the proper switching setting for the desired modes (default switch set- tings are for half duplex). When the unit is powered on, verify the correct modes of operation by examining the LEDs for each port. No further configuration is necessary. If the correct mode of operation does not appear in the LED display, check the cable and connecting equipment. If changes are made, power the unit off and then on again to reset.

▼Use of the optional AUI on Port 1 will negate the ability to use the RJ45 for that port.

▼If the Link/Duplex LED for a port is not lit, please check the cable being used. The port will only be operational if the LED is green (Good Link/Half Duplex) or yellow (Good Link/Full Duplex).

Power Requirements

The Lantronix LMS8-A is shipped with either a 120VAC (-01 version) or a 220VAC (-02 version) power supply. Input power requirements are 15 volts at 1.0 Amps.

CAUTION:

Not for installation in air ducts or plenums or other environmental air handling spaces. Changes or modifications to this device not explicitly approved by Lantronix will void the user’s authority to operate this device.

3