B. INSTALLATION WITH ANOTHER BRAND OF COOKTOP (Figure 8)
The installer will need to have the cooktop installation instructions available to complete the installation. All cooktop dimensions should be verified through measure- ment prior to cutting the countertop:
CCW = Cooktop Cutout Width
CCD = Cooktop Cutout Depth
COW = Cooktop Overall Width
COD = Cooktop Overall Depth
with the above dimensions confirmed, determine the cutout size as follows:
1 . Find the cutout width, (CW):
If CCW is smaller than the UCV cutout width then:
Installation | CW |
UCV30 | 28 |
UCV36 | 34 |
UCV45 | 43 |
If CCW is larger than the UCV cutout width then:
CW = CCW
See Figure 8 for UCV cutout widths and dimension definitions.
* Refer to Table 3 Notes on previous page.
2 . Calculate the cutout depth, CD: Determine the cooktop overhang (CO)
CO =
CD = COD -
3 . Determine setback (SB) distance from front of countertop to front of cutout. SB is specified in the installation instructions shipped
with the cooktop.
4 . Backsplash thickness must not exceed BT as calculated below:
BT = 24 7/8" - SB+CO - OD -
5 . Verify that the available flat countertop has a width greater than OW and a depth greater than OD.
OW depends on the installation:
UCV30: OW equals the greater of COW or 30".
UCV36: OW equals the greater of COW or 36".
UCV45: OW equals the greater of COW or 45".
OD is determined by:
6.Cut countertop using dims: CD, CW and SB as defined in Figure 8.
Figure 8 | INSTALLATION WITH OTHER COOKTOPS WHERE SPECIFIED | ||||||
|
|
|
|
|
|
| (SEE PART B) |
|
| - | UCV45 | ||||
|
|
| - | UCV30 |
| ||
|
|
|
|
| |||
|
| - | UCV36 |
| |||
|
|
|
| ||||
| 43 |
|
|
| |||
| 28 |
|
| ||||
|
| 34 |
|
|
|
|
|
1/8" |
|
|
|
|
|
|
|
BT |
|
|
|
|
|
| CW |
|
|
|
|
|
|
| |
|
| CD |
| OW | |||
|
| OD |
|
|
|
| |
|
|
|
|
|
| SB |
|
Page 9