Thermador UCV30, UCV45, UCV36 Verify Installation Operation & Cooktop Alignment, Step, Down button

STEP 8

VERIFY INSTALLATION,

OPERATION & COOKTOP

ALIGNMENT

Before performing this procedure, verify that all packing materials were removed from inside the lower enclosure front and that the grease filters have been properly installed. Refer to the Care and Use Manual for instructions regarding filter instal- lation.

Plug the vent power cord into a proper electrical recep- tacle and ensure that the circuit is energized.

A.Raise the snorkel to its fully extended position by pressing the Snorkel Up/Down button once (Figure 12). Do not hold the button. The elevating motor will stop when the snorkel reaches its full height. (Note: the blower will not operate unless the snorkel is fully raised).

B . Remove filters from packaging and install (refer to Care and Cleaning section for details).

C.Turn the blower ON by pushing the Low Blower Speed button on the snorkel (Figure 12). Let the blower run several minutes at each speed to evaluate its operation.

D.With the blower running, lower the snorkel to its fully retracted position by pushing the Snorkel Up/Down button once. The blower will immediately turn off.

Figure 13

Figure 12

Snorkel Up/

Down button

Blower Controls

E . Raise and lower the vent again. Check to make sure that the top cap on the snorkel does not catch on the back edge of the cooktop when it is lowered. If interference occurs, adjust the posi- tion of the cooktop by moving it against the front edge of the countertop cutout. Re-secure the cooktop to the countertop. Failure to eliminate interference may result in permanent damage to the vent. Also, ensure that the vent support legs have been properly secured to the cabinet base using the screws provided.

F . The height of the snorkel top can be adjusted so that the snorkel top cap is visible when installed with cooktops that have a higher cooking surface. Make this adjustment after installation is com- plete. First unplug the power cord, remove the J-Box cover, loosen the adjustment screw and push up on the adjustment bracket, (see Figure 13) .

NOTE: To prevent damage to any internal parts, the snorkel should be in the raised position when this adjustment is made.

If the vent system does not operate satisfac- torily during any of the above procedures, review all steps in these Installation Instruc- tions to ensure that nothing has been omitted or overlooked. Also, refer to the Care & Use Manual for additional information or call Thermador Customer Support 1-800-735- 4 3 2 8 .

Page 13