VIBE OWNER’S MANUAL — 3
REMOTE CONTRROL
LOW PASS FILTER
When Crossover Mode Selector is in Low Pass
Mode,this control limits the frequencies which
will be distributed to the speakers to those below
the value to which this is set.
POWER/PROTECTION INDICATORS
Provide amp power status and short-circuit
and thermal overload alerts.
4/6 CH INPUT MODE SELECTOR
Determines internal circuit routing depending
on whether or not a discrete Channel 5/6 input
signal is available from head unit.
BASS BOOST CONTROL
(CHANNEL 5/6 ONLY)
Increases sound level in lower frequencies by 18dB.
BAND PASS CROSSOVER CONTROLS
(CHANNEL 3/4 ONLY)
When Ch 3/4 Crossover Mode Switch is in
Band Pass position, these two controls are used
to establish the upper and lower frequency range
limits for the signals which will be distributed
to the Ch 3/4 speakers.
HIGH PASS FILTERS
When Crossover Mode Selector is in High Pass
Mode, these controls limit the frequencies which
will be distributed to the speakers to those above
the values to which these are set.
CROSSOVER MODE SELECTORS
(ALL CHANNELS)
Determine the mode of built-in crossovers;
low pass (permits only low frequency signals to
pass to speakers), high pass (permits only high
frequency signals to pass to speakers), or flat.
INPUT LEVEL CONTROLS
˄ALL CHANNELS˅
Enables the matching of input levels
to the output levels from the head unit
(or other signal source).
CH1
CH2
Low Input
Level
Min Max Full
High
pass
Mode
CHANNEL 1+2 CHANNEL 3+4 CHANNEL 5+6
CH6
CH5
High
Pass CH4 Level Mode High
Pass
Bass
Boost
Low
Pass Mode Level
Min Max
PROT
PWR
40Hz4kHz
Low Input CH3
40Hz 4kHz
Min Max
Full
Band
passHigh
pass
40Hz4kHz 40Hz 500Hz
40Hz500Hz
High
Pass Band
Pass Low
Pass
On Off
Input Mode
Ch4Ch6 Remote
Low
Pass Full
Low Input
VIBE532
FEATURES AND CONTROLS