MAXP42604 CHANNEL AMPLIFIER APPLICATIONS
Front/ear high pass, using a Z channel amplifier for mono sub bass
The combination of a 2 and a 4 channel amplifier, utilizing their built in crossovers. makes it a snap to put together a full system with front and rear highs. with mono sub bass.
Interconnect cable checklist:
-Using good quality RCA cables. feed the front and rear outputs of a head unit to the inputs of the 4 channel amplifier as shown.
-Also connect the LINE OUT of the 4 channel amplifier to the LINE INPUT of the 2 channel amplifier as shown.
Mono bass woofer wiring:
Connect the mono speaker positive terminal to the LEFT +, and its negative terminal to RIGHT
Switch .etting checklist.
4channel high. amplifier:
•1/2CH X'()VER: HP
•3/4CH
Z channel bilss amplifier:
• X'()VER switch: LP
Crossover frequency control checklist:
• 4 channel high. amplifier:
Channel. 1/2
•HIGH PASS: 100Hz LOW PASS: NfA
Channel. 3/4
•HIGH PASS: 100Hz LOW PASS: NjA
2channel bas. amplifier:
•HIGH PASS ISubsonlc filter,: 10Hz to 40Hz
Please note that these frequency points are suggestions only.
Refer to the loudspeaker manufacturer specifications and the section 'Settingup systems after installation for best performance"
Level control checklist:
-Refter to the section "Setting up systems after installation for best performance-
Minimun finalloud.peaker impedances:
•Z ohm per channel in .tereo mode. ·4 ohm mono bridged.
FRONT
INPlm
REJlR
INPlm
""'0
INlERCONNECT
RCII,"""
FUll RIoNGE
SPEAKERS
(:g
TOBATTERY+I'lV
VIA FUSE
FULlRloNGE
MONO SPEAKER
TOBATTERY+I'lV
VIA FUSE
-
