INSTALLATION
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow these mounting instructions.
Use the screw holes marked T (Toyota), N (Nissan) located on both sides of the unit to fasten the unit to the factory radio mounting brackets supplied with your vehicle.
Side view showing
Screw Holes marked T, N
When you install the front panel the unit will resume work automatically.
Factory Radio | Screw |
Mounting |
|
Bracket |
|
Screw
Dashboard or
Console
To fasten the unit to the factory radio mounting brackets.
1.Align the screw holes on the bracket with the screw holes on the unit, and then tighten the screws on each side.
2.Fasten with the supplied truss screws (5x5mm) or flush surface screws (4x5mm), depending on the shape of the screw holes in the bracket.
Note:
(1)The outer trim ring, sleeve and the metal strap are not used for method B installation.
(2)When the unit is on work, if you release the front panel, the unit will enter into the power off state automatically, and you can see the indicator LED flashing.
8
