Lathem LTR4-512, LTR8-512, LTR8-512M

LTRx-512 User’s Guide

ENT.DATE: 04-03-2003

TODAY IS THURSDAY

ENTER TIME: 21:00

PRESS [#] IF CORRECT

Press the [#] key at the top (‘00’ seconds) of the new minute to accept. If the time or date is not

correct, press [*] to cancel and try again.

The display will now show the time and date you just entered. You can toggle between the

12-hour and 24-hour display using “Quick Check” command [3]

Make sure you enter the correct date and day, because the schedules you setup depend on

these choices

[2]=Select Clock Control

This function requires the administrator password

Use this function to choose the make/model of the clocks that your Master will synchronize

(Note: The LTR4-512 can only synchronize one type of secondary system)

Enter your administrator password, then start this function by pressing [#][2][#]

ENABLE CLOCK CIRCUIT

SELECT CLK1 CODE: NN

[#] FOR CODE LIST

Enter the 2-digit code for CLOCK1, then press [#]. If you entered a code other than ‘00’, and

you have a LTR8-512 or LTR8-512M, you will see

ENABLE CLOCK CIRCUIT

SELECT CLK2 CODE: NN

[#] FOR CODE LIST

Enter the code for CLOCK2, or [0][0] if you will not use a CLOCK2, then press [#]

PRESS [#] IF CORRECT

Enter [#] to confirm or [*] to cancel and try again