Legacy Car Audio LCD17A specifications Trouble Shooting, General Controls

General Controls

1.OPEN BUTTON

To remove the front panel from the main body, press the RELEASE key, and the anti-theft LED indicator will keep flashing until the front panel is re-fixed to the main body.

2.POWER ON/OFF

In power off (ACC on) mode, turn on the unit by pressing the POWER button on the front panel. You can also turn on the unit by inserting a disc into the CD slot.It will start playing the first track on the disc. Press the POWER button to turn off the unit.

3 & 4.VOLUME UP(+)/DOWN(-) BUTTONS

Press the volume UP(+) or DN(-)button to raise or lower the volume level during playback. Both buttons are also used to adjust the settings for Bass, Treble, Balance, Fader, when you are in those audio modes.

5.MUTE ON/OFF BUTTON

Press the mute(MU) buttont to turn off the sound temporarily. Press it again to resume listening.

6.AUDIO FUNCTION AND MENU SELECT/ADJUST 1)Audio mode select and adjustment:

Press the SEL button repeatedly to cycle through four audio modes: -> VOLUME ->BASS ->TREBLE -> BALANCE -> FADER

After selecting a certain audio mode, you can adjust the setting for Bass, Treble Balance, fader by pressing the UP(+) or DN(-)button.

The control mode of E.VOL is operated with following numeric display.

-VOL: (MIN)00, 01,......45, 46(MAX).

-BASS/TREB: -6, -5,...,00,...5,6

-BAL: 9L, 8L,...,00,...8R,9R

-FAD: 9F,8F,...,00,...8R,9R

In each mode, the waiting time is about 3 seconds before it returns to the last display mode of RADIO or CDP mode.

7. EQ BUTTON

Press the EQ button to access the preset equalizer mode. Press it repeatedly to choose EQ OFF, or 4 preset equalizer curves: FLAT, CLAS, ROCK, POP. The audio output will change correspondingly.

8.LOUDNESS BUTTON

Pressing and holding the LOU button will activate LOUDNESS function for

enhanced bass sound at low levels. Pressing and holding it again will cancel loudness effect.

TROUBLE SHOOTING

Before using the check list please make all the connections first.

If you still have questions after going through the checklist, please consult your local customer service representative.

PROBLEM	CAUSE	SOLUTION
		If the power supply is properly
No power	The car ignition is not on.	connected to the car, switch the
		ignition key to " ACC "
	The fuse is blown	Replace the fuse
	Another CD is present in the	Remove CD in the player, then insert
	player	a new one with label face up
	Disc incorrectly inserted	Insert the CD with label face up
	upside-down
Disc cannot
	CD is extremely dirty or	Clean the CD or try a different CD
be loaded or
	defective
ejected
	Temperature inside the car is	Give enough time for the temper-
	too high	ature in the vehicle to cool down.
	Condensation	Turn off the player for at least an
		hour, then try again.
	Volume is too low	Adjust volume to desired level
No sound
	Wiring is not properly	Check the wiring connection
	connected
	The installation angle is more	Adjust the installation angle to less
Sound skips	than 30 degrees	than 30 degrees
	CD is extremely dirty or	Clean the CD or try a different CD
	defective
The radio does	The antenna cable is not	Insert the antenna cable firmly
not work
	connected

Page 3 Page 8