Calibration | Leica 788472 specification

Calibration		EN
Calibration of tilt sensor (Tilt Calibration)
1	2	3
2 sec

simultane-

ously

Place device on absolutely flat surface.

180°

4

5

6

		Turn the device horizontally by 180°			Place device on absolutely flat surface.
		and place it again on absolutely flat			Place device on absolutely flat surface.
		and place it again on absolutely flat
		surface.
					After 2 sec
			180°		the device
	7	8	180°	9	i goes back to
	7	8		9	i goes back to
					the normal
					mode.

Turn the device horizontally by 180° and place it again on absolutely flat surface.

Leica DISTOTM E7400x 788480a	16

Image 17

Leica 788472 manual Calibration of tilt sensor Tilt Calibration

Contents

Original laser distance meter Leica Distotm E7400x Table of Contents Introduction Overview Instrument Set-up Display Insert batteries When batteryBle use, do not Batteries Adjusting measuring reference / tripod Switching ON/OFF ClearOperations Press button 2 sec and ref- i erence from Multifunctional endpiece Distance unit setting Tilt unit settingTimer automatic release Keypad lock on Keypad lock OFF Beep ON/OFF Illumination ON/OFF Measuring single distance Measuring FunctionsPermament / Minimum-Maximum measuring Add / Subtract Partial Measurements Area Volume Aim laser at first Aim laser at sec Triangular area Aim laser at upper point Pythagoras 3-pointAim laser at lower point Result is shown in the main Above Point Tangular point Pythagoras partial heightAim laser at 2nd Stake out Height tracking Smart Horizontal ModeAim laser at tar- get Up to 360 and a transverse tilt of ±10 Memory is completely deleted Memory 20 last displays Delete Memory Calibration of tilt sensor Tilt Calibration Calibration Tilt measurements a transverse tilt should be avoided Technical Data Message Codes Warranty Safety InstructionsCare Areas of responsibility Prohibited use Permitted useHazards in use Limits of use Labelling FCC statement applicable in U.SLaser classification