Lenmar Enterprises Camcorder & Digital Camera operating instructions Introduction, Features

OmniSource® AC Power System

Camcorder & Digital Camera

AC Power Supply & Battery Charger Kit

PLEASE READ THE INFORMATION AND FOLLOW ALL INSTRUCTIONS THOROUGHLY BEFORE USING THIS PRODUCT.

INTRODUCTION

The OmniSource Power System is a complete AC Power Supply/Charger solution for use with many popular cameras and camcorders. The Universal AC “switching” power adapter works with 100V –240VAC to allow for trouble free use domestically or overseas. The power adapter can be plugged directly into the camcorder or camera for virtually unlimited record time, or plugged into the included charger module to charge batteries conveniently, away from the camera.

FEATURES:

•100-240V switching AC power adapter for use domestically and overseas.

•Plugging your camera into the power adapter provides unlimited operating time without requiring an on-board battery.

•Allows you to recharge your battery with the included charger module, leaving the camcorder/camera free for use.

•Charger module includes 2-color LED charge status indicator - RED (charge) / GREEN (full).

OPERATING INSTRUCTIONS:

To power the camcorder/camera:

1.Plug the end of the AC power adapter cord into the camcorder/camera. Often, this connection will be identified on the camcorder/camera as “DC IN”. Make sure the connector from the power adapter fits the camcorder/camera properly. If it does not, it may be the wrong type for your camcorder/camera. Once the power

adapter has been properly plugged into the camcorder/camera, plug the AC power adapter into the wall. Power up the camcorder/camera and operate as you would normally. Many new camcorders and cameras will charge the batteries on the camera unit itself. For these units, simply follow the directions supplied from the manufacturer while the camcorder/camera will be powered by the OmniSource Power System. The battery will charge just as it would when plugged into the manufacturer supplied power adapter.

2.When you wish to disconnect the power adapter, first turn the camcorder/camera unit off then unplug the power connector.

To charge the battery using the Charger Module:

IMPORTANT WARNING:

This CHARGER MODULE is for charging rechargeable Li-Ion batteries ONLY! Attempting to charge any other type batteries may damage the device, destroy the batteries and/or cause personal injury.

1.Plug the connector at the end of the AC power adapter cord into the charger module, then plug the adapter into the wall socket. With power present, the LED on the top of the charger module will glow

GREEN.

2.Slide your Li-Ion battery into the charger module, making sure the battery has proper connection with the charger module contacts. The LED indicator in the charger module will turn RED to indicate your battery is receiving fast charge. As soon as the battery is fully charged, the LED indicator will turn GREEN to indicate your battery is ready for use. Once the battery is full, remove the battery from the charger module and unplug the power adapter and charger module.

NOTES:

•It is normal for the switching AC power adapter, charger cradle and battery to become warm during charge or regular operation.

•If the charger does not charge the battery, check to see if the battery was already fully charged, is dead, faulty or worn out. All rechargeable batteries will eventually wear out after being charged for a certain numbers of cycles.

•Always keep metal contacts on both charger and battery clean. If cleaning is necessary, wipe the contact surfaces with a dry, soft and clean cloth.