Hasselblad 70480533, 70380554, 70480542 Power, Battery status rechargeable battery only, Standby

H4D

	Battery status (rechargeable battery only)		15
15
	An immediate full-screen information and battery status check appears on the grip
	display­	by holding down the illumination/battery status button. This screen displays:

• the firmware version

•the number of captures taken since the last battery recharge / change.

•a rechargeable-battery status icon that provides a quick visual check as well as a figure estimate in percent.

The information regarding the number of captures taken is intended to help you make an estimate of the number of possible remaining captures according to your way of work- ing. For example, if you regularly browse a great deal when shooting or you leave the camera in ON-mode with no standby, you would naturally expect to drain the battery sooner than others who don’t. You should soon be able to build up a picture of how you usually work and can therefore estimate that after X number of captures, you normally expect to be able to take Y captures before the battery is exhausted (when working in a similar manner in similar conditions).

The percentage information, however, provides another kind of estimate based more on the amount of power left in the battery rather than on your normal way of working.

Remember that these are only estimates and that there are a number of factors affecting remaining battery, ambient temperature for example, as well as general practice.

  Power

The camera can be set at two active power modes − ON or Standby − as well as OFF. In active modes, battery consumption is least in Standby mode and most in ON mode. The camera enters Standby mode to preserve battery consumption after 10 seconds

(Default)­ but can be changed in Custom Options #1. Both the grip and the sensor unit displays are dimmed accordingly. The sensor unit can be set to become independently inactive in Power Down (Menu > Settings > User Interface > Power Down).

However, after 15 minutes of complete inactivity, the whole camera will turn off automati- cally to conserve power (indicated by no visible logos on either display).

ON

To activate the camera press the red ON.OFF button until you see the start-up H4D logo appear on the grip display. The logo is automatically followed by the main screen. The camera is now in ON mode.

After a set period of inactivity (programmable in Custom Options) the camera automati- cally enters Standby mode, signalled by the appearance of the H4D logo again.

Standby

In this mode the camera is in a mainly inactive ‘standby’ mode and is ready to be imme- diately reactivated to the ON mode by:

•pressing the shutter release button half way

•pressing the Stop down button

•clicking the ON.OFF button

•pressing the Mirror up button.

In this mode, signalled by the standby H4D logo appearing on the grip display, the ­demand on the batteries is very low. It is ideal for general use where intervals between shots exceed a few seconds.

Standby mode is automatically set from the ON mode after 10 seconds (default) of ­inactive use (programmable in Custom Options #1).

27