Hasselblad 70480532, 70380554, 70480542, 70480522, 70490533 Inserting a card, Removing a card

H4D

			Using compact flash memory cards
1	2
			When using a compact-flash card, the H4D is completely self-­
		A	contained. No additional wires or connectors need to be ­attached.
			The H4D is shipped with a 4GB (or larger) compact-flash card,
		B	which is capable of holding approximately 50 − 100 captures
			(according to model). Lossless compression is applied to the
			images, so the actual size of each capture can vary, thereby
			affecting the total number of shots you can fit on the card.

Inserting a card

3	4
		1.	Open the CF card slot cover on the sensor unit.
		2.	Behind the cover, you will see a slot for the card (A) and a
			release button (B) below the slot.
		3.	Hold the compact-flash card so that the connector holes face
			into the slot in the sensor unit, with the brand label facing in
			the same direction as the sensor unit preview screen, as in the
			illustration. Gently press the card into the slot. If you encoun-
			ter resistance, it might be because you are holding the card
			backwards or upside down.
		4.	If the card can be easily inserted nearly all the way into the
			unit, then you are inserting it correctly. Press the card another
			couple of millimeters firmly into place.
		5.	Close the slot cover shut again.

12

1

2

Removing a card

1.Open the CF card slot cover on the sensor unit.

2.Press the release button a little way in to release it into the active position.

3.Press the now extended release button all the way back into the sensor unit again. Some force is required. As you do this, the card will be pushed out a few millimeters.

4.Grasp the card and pull it away from the sensor unit.

5.Close the slot cover shut again.

34

60