GENERAL INFORMATION
These decorative screen doors are offered in two attractive finishes and fit on the face of the appliance over the glass doorframe. If you encounter any problems, need clarification of these instructions or are not qualified to properly install this kit, contact you local distributor or dealer.
WARNINGS
Hot! Do not touch! The decorative screen doors and the glass behind the screen doors will become hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. Carefully supervise children in the same room as appliance.
•These decorative screen doors are NOT heat guards and are not intended to prevent burns.
•Operate the doors by only using the door handles. Avoid touching the doorframe, screens, or the glass enclosure, if the door is opened.
•Use care when opening doors. Avoid exerting any downward pressure on the doors when they are in an open position. Excessive force can cause the doors to come loose or be damaged.
•INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD!
INSTALLATION INSTRUCTIONS:
1. Remove and retain the Lower Panel per instructions in Figure 1.
Retain the lower panel for future use in case the Style View Door Kit is ever removed.
*NOTE: The fireplace is equipped with a
*2.Remove the Piezo / Switch Bracket from fireplace control compartment by pulling it forward as shown in Figure 2 (also see Figure 6).
Piezo & Switch
Bracket
Piezo & Switch
Locating Bracket
Figure 2
*3. Disconnect the black and white wires from the ON/OFF switch.
*4. Remove the ON/OFF switch from the bracket by squeezing the flex catches on sides of switch until it releases from bracket.
*5. Reinstall the bracket with the piezo (reverse Step 2).
6. Remove Doorframe from packaging. Install as follows:
*a.Position switch wires in front, inside of control compartment (so they can easily be reached after doorframe is in position).
b.Position the bottom of the doorframe so that the bracket on the inside of the doorframe locks behind the cabinet bottom flange as shown in Figure 4.
*c. Feed the switch wires through the switch mounting bracket on doorframe as shown in Figure 3.
Removethislowerpanel |
|
by lifting it up and out. | Figure 1 |
Switch Mounting
Bracket on
Doorframe
Figure 3
Wires for ON/OFF switch
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.