5.Secure the grill in position using two M6 screws and two no. 8 self tapping screws as shown in Figure 14.

Figure 14 - Secure Grill In Position

17.0 FITTING THE GLASS FACIA

The glass facia panel is supported by four M6 screws which protrude from the front of the outer casing. Insert the M6 retaining screws and ensure they are unscrewed approximately 1/8” so the keyhole shaped holes may engage, and the facia can be hooked on. Ensuring that the corresponding keyhole shaped holes engage the screwheads fully. Refer to Figure 15.

Figure 15

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE

18.0 FITTING THE SIDE PANELS

Remove the two side panel assemblies from the protective packaging and fit onto the sides of the firebox as shown. Insert the M6 retaining screws in the sides of the firebox and ensure they are unscrewed approximately 1/8” so the keyhole shaped holes may engage, and the sides can be hooked on.

Note : Front frame/facia not shown for clarity.

Figure 16

Insert a screwdriver through the holes in the right hand side panel to access the two M6 fixing screws (designated ‘a’ in Figure 17) and tighten fully. Next insert two no.8 self-tapping screws (designated ‘b’ in Figure 17) through the side panel support bracket, and the corresponding holes in the side of the firebox. Tighten fully. Repeat for the left hand side panel, which is secured by tightening the M6 ‘a’ screws only. The right-hand side panel has a hinged flap to allow access to the control knob.

‘a’

‘a’

‘b’ ‘b’

Figure 17

11