Lennox Hearth E36ODGPE Operation and Care of Your Appliance, Variable Flame Height Adjustment

OPERATION AND CARE OF YOUR APPLIANCE

Appliance operation may be controlled by a remotely located wall switch.

Gas Controls/Control Compartment Access

The gas controls can be found beneath the bottom refractory. Remove the bottom refrac- tory by lifting it up. Remove the access cover (refer to Figure 1 ).

All Models -

Pilot Stage

Terminal

Ground (TP)

TP

Gas Outlet

To Burner

Pressure-Tap (Inlet)

	IN
TH TP
LO	HI
TH	OUT
	VENT

Pilot Gas

Outlet

PILOT

IN

Supply Gas Inlet

To light these appliances refer to the detailed lighting instructions found in both English and French on pages 14 and 15 of these instruc- tions respectively. The appliance lighting in-

Burner Stage	Regulator	Pressure-Tap
Terminal	Mounting Screw	(Manifold)
Figure 2		Dexen Electronic Gas Valve

structions may also be found on the pull out lighting instruction labels attached to the gas control valve. See Figure 1 for its location.

Variable Flame Height Adjustment

1.All appliances are equipped with a variable gas control valve. Flame height for these mod- els may be adjusted through a range between fixed low and high settings, alternately, while the appliance is in operation.

Adjust the flame height as desired after light- ing the appliance by rotating the variable ad- justment control knob located on the front of the valve (see Figure 2).

Weather Seal

Cover

Switch

2.When lit for the first time, this appliance will emit a slight odor for an hour or two. This is due to the “burn-in” of internal paints and lubricants used in the manufacturing process.

3.Keep lower control compartment clean by vacuuming or brushing at least twice a year. More frequent cleaning may be required due to excessive lint from carpeting, bedding materi- als, etc. It is important that control compart- ments, burners and circulating air passage- ways of the appliance be kept clean.

4.Always keep the appliance area clear and free from combustible materials, gasoline and other flammable liquids.

Orient Batteries Vertically

To Fit Within Box

Maintenance

The appliance should be thoroughly inspected before initial use and at least annually by a qualified service technician. However, more frequent periodic inspections and cleanings should be performed by the homeowner. Ho- meowner must contact a qualified service technician at once if any abnormal condition is observed.

Refer to the maintenance schedule for mainte- nance tasks, procedures, periodicity and by whom they should be performed. Always verify proper operation of the appliance after servicing.

IMPORTANT: TURN OFF GAS AND ANY ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.

Battery Replacement

The intermittent ignition system operates on 3 volts provided by two (2) "D" cell batteries. The batteries are located in a pack installed within the J-Box, behind the stainless ON/OFF switch panel. Refer to Figure 3.

Note: All batteries loose voltage when frozen or left for prolonged periods. It may be wise to remove batteries during extended periods of disuse.

4

Figure 3

Battery Replacement

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.