2.5 Mounting the MCU
Mount the MCU using either of the following options:
Option 1 - Velcro Fastening on a Horizontal Surface
Option 2 - Flush-mounting
The following sections describe how to mount the sensor for both
of these options.
Option 1 - Velcro Fastening on a Horizontal Surface
1. Choose a location based upon the guidelines in
“Choosing the Best Location for the MCU” on page 25.
2. Remove the four squares of Velcro fabric from the
kitpack. Clean the bottom of the housing with a
mild detergent and water to remove oils, etc. Peel
the protective backing from the squares and apply
them to the bottom of the housing at each of the
four corners (see Figure 2-20).
3. Position the four Velcro hook disks where the
MCU will be mounted. Drill screw holes for the
disks and secure in place with the #4-24 screws
supplied in the kitpack.
4. Press the MCU firmly into place so that the loop
material engages the hook disks.
54-0198
38
TracVision G8 Owner’s Manual - Guide to Technical Information
Figure 2-20
Mounting the MCU with
Velcro Attachments
Fabric Strips
Hook Disks