WIRING DIAGRAM MILLIVOLT GAS VALVES
|
| THERMOPILE |
APPLIANCE- MOUNTED |
| |
ON/OFF SWITCH |
|
|
|
| |
|
| TP |
|
| TH |
BK/W(1) | BK/W(1) | GAS VALVE |
THERMOSTAT (OPTIONAL)
WALL MOUNTED CONFIGURATION FOR FAN SWITCH (OPTIONAL)
BLACK |
|
BK |
|
R |
|
W |
|
GR | 120 V AC |
FAN |
|
(OPTIONAL) | JUNCTION BOX |
|
Figure 9
INTERMITTENT ELECTRONIC WIRING DIAGRAM
120 VAC
SPARK TO PILOT IGNITOR
BK W GR
| BK | GR |
OPTIONAL BLOWER |
| W |
SWITCH |
|
|
BK | R | IGNITOR MODULE |
JUNCTION BOX |
| 3V |
| BLACK (IGNITOR) | |
|
| |
TRANSFORMER 3V |
| BLACK (SENSOR) |
FAN
(OPTIONAL)
| BLACK |
|
|
|
|
| ORANGE (THTP) |
|
|
TO WALL | BATTERY |
| IN |
|
| BLACK (TP) |
|
| |
SWITCH OR |
|
| PILOT | |
THERMOSTAT |
|
| LOHI | |
RED |
|
| IN | |
| GREEN (TH) | OUT | ||
|
| |||
|
|
|
| |
|
|
| VENT |
|
| BROWN |
|
|
|
| BROWN |
|
|
|
Figure 10
Step 10. Install the
Step 11. Route a
Then route the wires to the unit’s junction box. Remove the receptacle box by squeezing the sides of the
Step 12. Connect the supply wires to the receptacle as shown in Figure 9 (for Millivolt) and Figure 10 (for Electronic). Reinstall the receptacle box.
Step 13. Plug the blower cord into the receptacle (see Figure 11 ).Step 14. Reinstall items from Steps 7, 6 and 5.Step 15. Restore the electrical power to the unit.Step 16. Start the fireplace by following the procedures indicated in the lighting instructions section of the Homeowners Care And Operations instructions manual, supplied with the fireplace.
Step 17. Check the
IMPORTANT: Ground lead must be connected to the green screw located on the junction box. Failure to do so will prevent the appliance from operating. The appliance must be electrically grounded in accordance with local codes or, in the absence of local codes, the National Electrical Code, ANSI/NFPA
BLOWER ASSEMBLY
BLOWER MOUNTING TABS
ELECTRICAL OUTLET
Figure 11
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. | 3 |