8
WARNING: THIS APPLIANCE IS NOT MEANT TO BURN WOOD. ANY ATTEMPT TO DO SO COULD CAUSE IRREPARABLE DAMAGE TO YOUR APPLIANCE AND PROVE HAZARDOUS TO YOUR SAFETY.
WARNING: THE SIZE AND POSITION OF THE LOG SET WAS ENGINEERED TO GIVE YOUR APPLIANCE A SAFE, RELI- ABLE AND ATTRACTIVE FLAME PAT- TERN. ANY ATTEMPT TO USE A DIFFER- ENT LOG SET IN THE FIREPLACE WILL VOID THE WARRANTY AND WILL RE- SULT IN INCOMPLETE COMBUSTION, SOOTING, AND POOR FLAME QUALITY.
The logs are packaged within the firebox. The bag of rockwool is in the lower control compartment. Remove the rockwool from the packaging and tear into dime size pieces (Figure 10 on page 8 ). Spread across the burner evenly. Do not use more than is necessary to cover the burner. When prop- erly positioned, the rockwool will unevenly cover approximately 85% of the burner with no appreciable gaps.
These appliances are equipped with a beauti- fully crafted five (5) piece ceramic fiber log set. The logs, shown in Figure 11 on page 8, are to be positioned precisely as shown. Any modi- fication to the to the lay of these logs may result in sooting, property damage and injury or death.
All logs that engage pins have mating holes for pin engagement on their bottom sides. DO NOT force a hole into a log by engaging the pins where they are not intended to go. Apparent minor
Step 1. To position the logs, begin by placing the rear log (c) in position over the two pins located at the right center rear and right rear of the log grate (refer to Figure 11 ).
Step2. Position the front log (a) over the two pins found near the front left corner of the log grate. This log should be positioned with the split "V" notch to the front with the bulkier half of the "V" to the left.
Step 3. Place the "C" shaped main log (b) in position over the remaining log grate pin lo- cated at the far right near the front of the grate. The left end of the main log is to rest upon the "V" shaped front log with its back left edge butted up against the rear log (c).
Step 4. Position the top log (d) over the pins in the rear log and the main log. When prop- erly placed, the top will have its charred area to the left and the stubbed end toward the front.
Step 5. Position the rear top log (e) in the pocket formed over the left side of the rear log
(c). The split face of the rear top log (e) must be facing forward, It's left end should be down fully against the log rack, and the crook (bend) in the log should break directly over the end of the rear log.
When properly positioned the logs should appear as illustrated in Figures 11 and 12. Logs must not impinge any of the flames.
WARNING: IF USING THE OPTIONAL EMBER KIT, DO NOT PLACE ANY OF THE KIT COMPONENTS IN ANY LOCATION WHERE THEY MAY IMPINGE ON THE LOFTING FLAMES. GIVE CONSIDER- ATION TO THE POTENTIAL OF LATER INADVERTENT DISLOCATION OF THESE ELEMENTS AND ENSURE THEY ARE PLACED WHERE THEY MAY NOT FALL OR ROLL INTO AN IMPINGING LOCA- TION. FLAME IMPINGEMENT WILL RE- SULT IN SOOTING AND MAY CAUSE SERIOUS INJURY OR DEATH.
Figure 10
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
e. |
d. |
c. |
b. |
a. |
Figure 11 |
7" |
Figure 12
