REMOTE CONTROL OPERATION

The Reflections Electric Fireplace is provided with an Infrared Remote Control. All functions of the fireplace are provided through the remote. The remote provided with the T.V. should not be used.

The functions identified on the remote (see Figure 18 ) are as follows:

A. All ON/All OFF

Press once; the embers light and the flame come on after a brief warm up period. Pressed again and all functions end immediately.

B. Embers ON/OFF

This button will turn the embers ON and OFF independent of the main button.

C. Menu

To activate the menu for adjusting color and brightness.

D. Heater ON/OFF

This button will turn the heater ON and OFF after the unit is activated.

E. Volume

Increase:

Decrease:

F. Setting Control

Increase: +

Decrease: –

G. Flame Speed

Alternates between fast and slow flame speed.

COLOR ADJUSTMENT

To adjust Color, Tint and Brightness, use the Menu (button C) along with E and F as follows. The menus displayed will be upside down and backwards. This is a step that should only be required once.

10

PICTURE ADJUSTMENT

The television will come with all adjustments at normal. If you wish to enhance the color, adjustments can be made.

Step 1. Press the MENU button so that the

menu display appears on the TV screen.

Step 2. Press the VOL(ume) button so that "PICTURE" is selected.

Step 3. Select the feature you wish to adjust with the MENU + or – button and adjust

it with the VOL(ume) or button.

BRIGHT

Adjust until the whitest parts of the picture are as bright as you prefer.

+: Increase Brightness, – : Decrease Brightness

CONTRAST

Adjust to increase or decrease contrast.

+ : Increase Contrast,

– : Decrease

Contrast

 

COLOR

Adjust to be a brilliant or pale color.

+ : Be Brilliant Color, – : Be Pale Color

TINT

Adjust to obtain natural flame tones.

+ : Greenish Tone, – : Reddish Tone

TROUBLESHOOTING

Due to the nature of all electronic devices, interference from other electrical sources could set the units out of phase. The television and DVD player could operate with one ON and the other OFF rather than both ON, both OFF. If this occurs, the television can be turned ON (or OFF) manually with the button (shown in Figure 18 ). This will put the units back in sync from that point forward.

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

AD B

EC

F

G

Figure 18

REPLACING LIGHT BULB

This fireplace uses a 120 Volt, compact fluorescent light bulb (900 Lumens). The light is located under the ember bed of the unit.

CAUTION: DO NOT EXCEED A 15 WATT BULB. USE OF A HIGHER RATED BULB MAY RESULT IN A FIRE, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.

CAUTION: DO NOT REPLACE THE COMPACT FLUORESCENT LIGHT BULB WITH AN INCANDESCENT BULB.

1.Turn off power to the unit.

2.Let the fireplace cool, if it has been operating.

3.Remove the glass reflector panel. Remove logs and ember bed.

4.Examine the bulb to determine if it needs to be replaced.

5.While holding the socket, unscrew the de- fective bulb.

6.Install the new light bulb by screwing it in while holding the socket.

7.Reinstall the ember bed, log set and glass panel.