New construction or renovation
1.Select a location that is not prone to moisture and is located at least 3 feet (or 0.9m) away from combustible materials such as curtains or drapes, furniture, bedding, paper, etc.
2.Place the unit in selected location to see how it will look in the future.
3.Mark the desired location on the floor and store unit in a safe, dry and dust free loca- tion.
4.Frame in an opening leaving at least 1/4" (6mm) around the edge of the unit. Any new wiring must be done in compliance with local and national codes and other applicable regula- tions in order to reduce the risk of fire, electric shock or other injuries. Therefore, it is strongly recommended that you hire a professional to complete any such work.
Installing the fireplace insert
1.Once the site has been prepared, the fireplace insert can be installed.
2.Make sure the switch is in the "OFF" position.
3.Plug the fireplace into a
4.Push the fireplace insert so that the trim is against the finished mantel or wall surface.
Warning: Grills on this elec- tric fireplace cannot, in any way, be covered as it may create a fire hazard.
Notes: Power supply service must be complete prior to finishing, to avoid reconstruction. Grills and air openings cannot be covered in any circumstances.
Operating instructions
The controls (see Figure 4 ) are located on the bottom right corner of the unit.
1.Plug in your electric fireplace.
2.Main ON/OFF Power Switch: This switch is located on the right side of the control panel (see Figure 4 ). When the unit is on, the default settings for the fireplace is HI ember bed and flame and the heater is OFF.
Flame Control
Button
ON/OFF Power
Button
FL TM
Remote Control
Receiver
Temperature
Control Button
Temperature
LED
Figure 4
3.Temperature Control Button and LED: This button is located to the left of the Remote Control Receiver (see Figure 4 ). The LED is located to the right of the Flame Button. Push button to cycle through the settings. When this button is pushed, the LED will change to its corresponding color; Green for LO, Orange for MED, and Red for HI. When heater is on, heat will emit through vents located above the firebox opening panel (see Figure 6, page 7 ).
The heater has a built in thermostat so it will shut off automatically once the set temperature is reached. It will also turn on automatically if the room temperature drops below the set temperature.
Notes: When the heater is turned on for the first time, it may release a slight, harmless odor. This odor is a normal occurrence caused by the initial heating of the internal heating elements and should not occur again.
4.Flame Control Button: This button is located to the left of the Temperature Button (see Figure
4). After power is on, push the Flame Control Button to adjust flame and ember bed bright- ness. Press and release the Flame Control Button to cycle through LO, MED, HI and OFF.
Operating By remote control
(see Figure 5 )
1.Plug in your electric fireplace.
2.Push the ON/OFF Power Button to turn unit on. Power LED will light.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Infrared Ray Exit
Indicator
Light
Figure 5
3.When operating the remote control, it must be pointed at the sensor on the bottom PANEL.
4.The ON/OFF button at the top left of the remote is the main ON/OFF power button. Pressing this button activates the power to the unit.
5.To adjust the ember bed lighting and flame brightness, press the
The HEATER button activates the heater. The heater is
6.To turn off the fireplace, press the ON/OFF button once. When you restart the fireplace e with the remote control, all of the features you had set will remain in effect. Notice: This remote control must remain within 26 feet or 8 meters of the fireplace to be effective.
Note: Make sure your batteries are fully charged and installed correctly in your remote control.
