Lennox Hearth RAVL30 Reveal Corner Adjusted for Arch Face

15
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Facing Greater Than 1” (25mm) Thick:
If the combined thickness of the facing material (eg. brick or cultured
stone) and cement board is greater than 1”, then the facing material must
be placed around the face. A template (see kit part numbers below) should
be used while installing the facing material. Templates for the various faces
may be purchased from your Lennox Hearth Products dealer. Instructions
for installing the templates are included with the templates.
Template part numbers:
Arch Inset #75206
Classic Inset #75209
Foundry™ #75090
Adjustment prior to arched face installation:
The corners of the 1” (25mm) reveal around the fireplace opening need to
be adjusted prior to installing an arched face (see below). Remove screws
A and loosen screw B. Rotate the corner downward bending the metal at
pivot point C until the holes from which screws A were removed line up
with the lower set of holes. Reinstall screws A and tighten screw B. When
finished, the corners should look like the corner below at the far right.
Figure 11
Figure 12
Figure 13
Figure 10
Platform to raise fireplace to accommodate a
hearth extension greater than 1” in thickness.
Template
Template
Reveal Corner
Reveal Corner
Expanded View of
Reveal Corner
A
B
C
Expanded View of Reveal Corner
A
B
C
A
A
Reveal Corner Adjusted
for Arch Face
Reveal Corner Adjusted
for Arch Face