Backing
|
| Double |
|
| Sided |
|
| Tape |
Backside of Side |
| |
Trim Panel |
|
|
|
|
|
Figure 4
Backside of Top |
|
|
|
|
| Magnet | |
| ~ 3” |
|
|
| |||
Trim Panel |
|
|
|
|
|
| |
| Typical |
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
| ♦Top Channel | |||
|
|
|
|
|
| ||
|
|
|
|
Figure 6 | ♦ Black Trim kits do not include channels or |
tape. See Note on page 1. |
Step 4. Install the side trim panels onto each side of fireplace face as follows:
Brass and Stainless Trim Kits – Place side trim over channels, then press firmly so double sided tape adheres panels to channels (see Figure 5 ).
Black Trim Kits – Place side trim panels over magnets on each side of the fireplace face as shown in Figure 5.
Note: Magnets were installed on Step 1, Figure 2.Right Side
Trim Panel
Figure 5
Step 5.
Brass and Stainless Trim Kits - Peel off the backing on double- sided tape on the backside of the top trim panel. Press fit the top channel against the top trim panel as shown in Figure 6.
Black Trim Kits – Proceed to Step 6.Step 6. Place 2 magnets on the backside of the top trim panel as shown in
Figure 6.
Brass and Stainless Trim Kits – The metal channel should go behind the side trim panels. Squeeze top and side trim pieces together.
Black Trim Kits – The magnets act as support to hold the trim panel in place.Figure 7 Completed Trim Panel InstallationNOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
LENNOX reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinued colors, styles and products.
Consult your local distributor for fireplace code information.
Printed in U.S.A Lennox Hearth Products 2004 |
| 1110 West Taft Avenue • Orange, CA 92865 |
P/N 775,175M REV. B, 12/2005 | Page 2 of 2 |