Lennox International Inc BV4000C operation manual Surround Assembly, Installation

INSTALLATION

SURROUND ASSEMBLY

NOTE: Do not face seal over chimney cooling air system on superior brand or any brand fireplace which is designed with the chimney cooling air sys- tem.

13.Pull the insert slightly forward to its desired position; attach the face shield using the surround clips and hardware as shown. The fiberglass insulation strips should be secured along the top and sides (step 3). Assemble the gold-tone trim using the 2 inside cor- ner brackets. Attach trim to the face shield and stove.

Push the unit back until face shield insulation is com- pressed against the fireplace front, forming a tight seal.

Test for air leaks by holding a candle around edge of face shield to see if smoke is pulled into fire- place.

*Note: Preferred method of attaching connector to flue outlet is to install two L-Brackets (1” angle bracket, 3/4” wide) on opposite sides of the flue outlet: Use self- tapping screws to secure in place. Cut a ½” (height) and ¾” (width) notch in the front of connector (pipe, liner or adapter that will attach to flue outlet). Install connector into flue outlet and secure to angle brackets using ma- chine screws. Seal around connection with furnace ce- ment.

PAGE 10