FRU tests

The following table shows the test for each FRU.

Table1. FRU tests
FRU Applicable test
System board 1. Diagnostics --> CPU/Coprocessor
2. Diagnostics --> Systemboard
3. If the docking station or the port replicator is attached to the
ThinkPad computer,detach it. Place the computer on a
horizontal surface, and run Diagnostics --> ThinkPad Devices
--> HDD Active Protection Test.
Note: Do not apply any physical shock to the computer while
the test is running.
Power Diagnostics --> ThinkPad Devices --> AC Adapter,Battery 1
(Battery2)
LCD unit 1. Diagnostics --> VideoAdapter
2. Interactive Tests--> Video
Modem daughter card
(MDC-3.0)
1. Make sure the modem is set up correctly.
2. Replace the modem jack and the modem card in turn, and run
the following tests in Diagnostics --> Communication:
a. Conexant Smart Modem Interrupt
b. Conexant Smart Modem Dialtone
Audio Enter the BIOS Setup Utility and change Serial ATA(SATA) setting
to Compatibility, and run Diagnostics --> Other Device -->
Conexant Audio
Speaker Interactive Tests--> Internal Speaker
Note: Once Modem/Audio test is done, the no sound is heard
this test. In this case, turn off and turn on the computer.Then, run
this test again.
PC Card slot Diagnostics --> Systemboard --> PCMCIA
ExpressCard slot 1. Insert a PCI-Express/USB Wrapcard into the ExpressCard slot.
2. Turnon the computer.
3. Run Diagnostics --> ThinkPad Devices --> ExpressCard slot.
Keyboard 1. Diagnostics --> Systemboard --> Keyboard
2. Interactive Tests--> Keyboard
Hard disk drive or
solid state drive
Enter the BIOS Setup Utility and change Serial ATA(SATA) setting
to Compatibility, and run Diagnostics --> Fixed Disks
Youcan also diagnose the hard disk drive without starting up the
operating system. Todiagnose the hard disk drive from the BIOS
Setup Utility,do as follows:
1. Remove any diskette from the diskette drive, and then turn off
the computer.
2. Turnon the computer.
3. While the message, “Tointerrupt normal startup, press the
blue ThinkVangatebutton,” is displayed at the lower left of the
screen, press F1 to enter the BIOS Setup Utility.
4. Using cursor keys, select HDD diagnostic program. Press
enter.
5. Using cursor keys, select Main hard disk drive or Ultrabay
hard disk drive.
6. Press Enter to start the diagnostic program.
Diskette drive 1. Diagnostics--> Diskette Drives
2. Interactive Tests--> Diskette
50 ThinkPad T400 and R400 HardwareMaintenance Manual