Also, in either of the following events, the computer automatically returns from
sleep (standby) mode and resumes operation:
vThe ring indicator (RI) is signaled by a serial device or a PC Card device.
vThe time set on the resume timer elapses.
Note: The computer does not accept any input immediately after it enters sleep
(standby) mode. Waita few seconds before taking any action to reenter
operation mode.
Hibernation mode
In hibernation mode, the following occurs:
vThe system status, RAM, VRAM, and setup data are stored on the hard disk.
vThe system is powered off.
Note: If the computer enters the hibernation mode while it is docked to the
docking station, do not undock it before resuming normal operation. If you do
undock it and then try to resume normal operation, you will get an error message,
and you will have to restart the system.
Tocause the computer to enter hibernation mode, do any of the following:
vPress the Fn+F12 keys.
vIf you have defined one of the following actions as the event that causes the
system to go into hibernation mode, perform that action.
– Closing the lid.
– Pressing the power button.
– Pressing Fn+F4 keys.
Also, the computer goes into hibernation mode automatically in either of the
following conditions:
vIf a “hibernation time” has been set on the timer, and if the user does not do
any operation with the keyboard, the TrackPoint,the hard disk drive, the
parallel connector, or the diskette drive within that time.
vIf the timer conditions are satisfied in suspend mode.
When the power is turned on, the computer returns from hibernation mode and
resumes operation. The hibernation file in the boot record on the hard disk drive is
read, and system status is restored from the harddisk drive.
Related service information 61