Replacing a memory module
Attention
Do not open your computer or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer. To obtain copies of the Safety and Warranty Guide, go to http://www.lenovo.com/support.
This section provides instructions on how to replace a memory module.
Note: Your computer has support for two memory modules.
1.Remove the computer cover. See “Removing the cover” on page 9.
2.You might have to remove the drive bay assembly to access the memory connectors. See“Accessing system board components and drives” on page 10.
3.Remove any parts that prevent access to the memory connectors.
4.Remove the memory module being replaced by opening the retaining clips.
Figure 33. Removing the memory module
5.Position the replacement memory module over the memory connector. Make sure that the notch 1on the memory module aligns correctly with the connector key2 on the system board. Push the memory module straight down into the memory connector until the retaining clips close.
Figure 34. Installing the memory module
6. Go to Chapter 4, “Completing the parts replacement,” on page 33.
