![](/images/new-backgrounds/1102831/10283159x1.webp)
5.Install the new drive into the blue bracket, flex the bracket, and align the pins 1 through 4on the bracket with the holes in the hard disk drive. Do not touch the circuit board 5 on the bottom of the hard disk drive.
Figure 23. Aligning the pins with the holes in the hard disk drive
6.Connect the signal and power cables to the rear of the hard disk drive.
7.Position the hard disk drive and bracket so that it engages the retaining clips in the bottom of the chassis when you slide the bracket to the right.
8.Slide the hard disk drive and bracket to the right until it snaps into position.
9.Go to Chapter 4, “Completing the parts replacement,” on page 33.