Lenovo C52 manual Install Monitor, Power Cord

E-3

INSTALL THE

MONITOR

•To connect the tilt/swivel base to the monitor, align hooks with the sockets on bottom side of the monitor, and gently push the base towards the front of the monitor.

•The 15-pin D-shell signal connector on the signal cable will connect easily to the video adapter output on your personal computer. Lock both screws on the connector to ensure a firm connection.

•Turn the PC power switch ON. Then turn the monitor power switch ON, by pressing the switch inward. The green power indicator will light up.

•Allow about 30 seconds for the CRT tube to warm up. Data will be displayed on the screen.

•If your display fails to function properly, please first refer to the section "Troubleshooting" in this manual.

POWER CORD

•Check first to make sure that the power cord you use is the correct type required for your area.

•This monitor has a universal power supply that allows operation in either 100/120V AC or 220/ 240V AC voltage area. No user-adjustment is required.

•First connect the power cord into your monitor’s power input socket, and then plug the other end into a 3-pin AC outlet. The power cord may be connected to either a wall socket or the power output socket on your PC, de- pending on the type of power cord supplied with your monitor.

•For units to be used at 120V AC:

Use a UL Listed Cord Set consisting of a min. No. 18 AWG, Type SVT or SJT three-con- ductor a maximum of 15 ft. in length and a parallel blade, grounding type attachment plug rated 10A, 125V.

•For units to be used at 240V AC (domestic use):

Use a UL Listed Cord Set consisting of a min. No. 18 AWG, Type SVT or SJT three-conduc- tor cord a maximum of 15 ft. in length and a tandem blade, grounding type attachment plug rated 10A, 250V.

•For units to be used at 220/240V AC (outside of U.S.):

Use a Cord Set consisting of a min. No.18 AWG cord and grounding type attachment plug rated 15A, 250V. The cord set should have the appropriate safety approvals for the coun- try in which the equipment will be installed and marked HAR.