Lenovo A50, M50e Series manual Replacing the cover and connecting the cables

6.Replace the cover and connect the power cord. See “Replacing the cover and connecting the cables.”

7.Restart the computer, leave it on for approximately 10 seconds. Turn off the computer by holding the power switch for approximately 5 seconds. The computer will turn off.

8.Repeat steps 2 through 4 on page 22.

9.Move the jumper back to the standard (pins 1 and 2).

10.Replace the cover and connect the power cord. See “Replacing the cover and connecting the cables.”

Replacing the cover and connecting the cables

After working with options, you need to install any removed parts, replace the cover, and reconnect any cables, including telephone lines and power cords. Also, depending on the option that is installed, you might need to confirm the updated information in the IBM Setup Utility program.

To replace the cover and connect cables to your computer:

1.Ensure that all components have been reassembled correctly and that no tools or loose screws are left inside your computer.

2.Clear any cables that might impede the replacement of the cover.

3.Position the cover over the chassis and pivot it down over the computer until it snaps into place.

4.Reconnect the external cables and power cords to the computer. See “Installing external options” on page 6.

5.To update the configuration, see Chapter 4, “Using the IBM Setup Utility program,” on page 77.

Chapter 1. Types 8149, 8177, and 8178 23