CD OPERATION
HANDLING A DISC
Although built to withstand a certain amount of the effects from dust, soil and scratches, discs should be treated with the care normally according to conventional analog discs (records). Always protect a disc against scratches, soil and dust etc. We recommend that during
Since any dirt, scratches or warping of the disc can cause
skipping or intermittent sound or noise, bear in mind the
following points:
• When holding the discs, take care not to touch the playing
surface.
• Store the discs in their cases. Return them to their cases with the label surface facing up and push down lightly on
the label surface.
• Do not place discs near a heating device or a place where the temperature is high or in dusty areas.
• Do not write on the label surface using a ballpoint pen and
do no stick labels on the CD.
• Wipe away any fingerprints or dust on the playing surface
of a disc using a soft cloth.
Bear in mind the following points when cleaning your discs:
- Always wipe from the inside toward the outside of the disc. - Never in a circular motion.
-Do not use conventional record cleaners,
CLEAN FROM CENTER TO EDGE benzene, thinner or other solvents.
PLAYING A CD (COMPACT DISC)
1.Press the Power Switch on and slide the Function Switch to the CD position, the
Power/Batt. Lamp will light and the Display will show 2 zeros “ 
”.
2.Press the CD Door Open Button (near the door) to open the CD door.
3.Insert a CD with the LABEL side facing UP (if the disc is upside down or damaged, the Display will show 2 zeros “
” and then “ 
”).
4. Close the CD Door by gently pushing the Door down.
5. The Display will show 2 zeros “ 
” and then the total number of tracks (songs) on the CD.
6.To start the music, press the CD Play/Pause Button (wait a few seconds for music
to start). The first track number “ 
” will appear in the Display, the Play/Prog Indicator will light and the disc will start playing.
7.Adjust the Volume Control to your taste. For extra bass sound, press the Bass
Boost Switch down.
8. To pause the music - if the phone rings or other reasons, press the Play/Pause Button, the track number will flash to remind you that you are in pause mode.
9.To resume the music from pause, press the Play/Pause Button again. The track number will be steady on (not flashing).
10.To stop playing music, press the CD Stop Button.
11.To turn off the CD, slide the Function Switch to TAPE position. To shut the power off, press the Power Switch again, and the Power/Batt. Lamp will go off.
7 |
| |
|
E
