Lenoxx Electronics CD-1492 Introduction, POWER SUPPLY- 2 WAY SYSTEM, A. Dc Operation

POLARIZED AC PLUG

INTRODUCTION

Your new COMPACT DISC PLAYER WITH AM/FM STEREO CASSETTE RECORDER is a specially designed all solid state set which, with proper care, will give you years of trouble-free service. Please read these operating instructions carefully as they will help you obtain maximum performance from this set. Unpack the set carefully and place it on a level surface, away from sources of excessive heat, such as radiators.

POWER SUPPLY- 2 WAY SYSTEM

This set is designed to be operated from two different power sources as listed below:

A. DC OPERATION

This set runs on 8 size “D” batteries. For best performance, always use heavy duty alkaline batteries.

TO INSTALL BATTERIES

1.Remove the BATTERY DOOR by gently pushing tabs downward and outward.

2.Install 8 size “D” batteries.

NOTE: The battery compartment has 2 levels,
upper and lower. Be sure to install the
batteries as per the sketch shown
and the indication on the back of the set.
3.Replace the BATTERY DOOR.
NOTE: Old batteries may swell and leak. To
avoid damage to your set, remove the
batteries when the set is to be stored for
long periods of time or if the batteries
become exhausted (when the batteries	NOTE: The negative polarity
become weak, the POWER/BATT. lamp will
be dim; when the batteries are completely	(side) of battery
dead, the POWER/BATT. lamp will be off).	touches the spring.

NOTE: To use your set on battery power, you MUST remove the AC power cord from BOTH the wall outlet AND the back of the set.

NOTE: Do not mix old and new batteries. Do not mix rechargeable (nickel cadmium) and regular carbon zinc or alkaline batteries. Installation of batteries should be done by an adult (for safety).

BATTERY INDICATOR

The POWER lamp also shows you if your batteries are fresh. When this lamp gets dim, it is time to replace the batteries.

B. AC OPERATION

Plug the AC power cord into the back of the set and insert the AC PLUG into 120 Volts AC 60Hz standard household outlet.

NOTE: This cord is polarized. This means either

end of the cord will only fit ONE way into the socket or wall outlet. If it does not fit, do not force it, just reverse it and try again.

NOTE: If the AC power cord is plugged into the back of the set, the set will not work on batteries. To operate the set on batteries,

remove the AC PLUG from the back of the set.

4IB-CD1492(AD)-WM-E-031402